1U 600W Single Output Industrial DC to DC converter (147mm width)


1U 600W Single Output Industrial DC to DC converter (147mm width)

Series Model No. Output Watts Input Voltage Input range
120 STC-120600XXIW 600W continuous ±120V DC ±80V ~ ±150V DC
48 STC-48600XXIW 600W continuous ±48V DC ±37V ~ ±71V DC
24 STC-24550XXIW 550W continuous ±24V DC ±19V ~ ±35V DC
12 STC-12500XXIW 500W continuous ±12V DC ±9V ~ ±18V DC
12 STC-12300XXIW 300W continuous ±12V DC ±9V ~ ±18V DC

Note: XX (where X=0~9) shows the output voltage

 
ENVIRONMENTAL CONDITIONS:
● Cooling: Forced Air-cooling, 38x38x20 mm Fan x 2 (With Two Ball Bearing) (for STC-12300XXIW)
38x38x28 mm Fan x 2 (With Two Ball Bearing) (for other models)
● Fan brand: DELTA, NMB, SUNON. Specifications are equivalent
● Operating Temperature: 0°C ~ +50°C (-20°C~+60°C optional) Full Load
● Operating Humidity: 20%~85% RH. (Non condensing)
● Storage Temperature -20°C~+80°C
● Storage Humidity: 10%~90% RH. (Non condensing)
● Operating Altitude 10M Below Sea level and 3000M Above Sea level
 
DC INPUT CHARACTERISTICS:
● Input connector type 40A/300V Single table type Terminal x 2
160A/300V Single table type Terminal x 2 / STC-12500XXIW
● Input Current  20A/40A(300W) @ 12V DC input, Full Load High Line & Low Line
  33A/55.5A(500W) @ 12V DC input, Full Load High Line & Low Line
  17.5A/35A(550W) @ 24V DC input, Full Load High Line & Low Line
  9.7A/18.6A (600W) @48V DC input, Full Load High Line & Low Line
  4.67A/8.6A (600W) @120V DC input, Full Load High Line & Low Line
● Inrush Current Less than 10A Cold start @25°C ambient
 
 
DC OUTPUT CHARACTERISTICS:
Output Voltage Regulation Output Current Ripple & Noise
Load Line Cross 600W 550W 500W 300W
Min Max Min Max Min Max Min Max
+5V ±5% ±1% ±5% 0A 120A 0A 110A 0A 100A 0A 60A 50mV
+12V 0A 50A 0A 46A 0A 42A 0A 25A 120mV
+24V 0A 25A 0A 23A 0A 21A 0A 13A 240mV
Maximum continuous total DC output power shall not exceed 600 550 500 300 Watt

 
OVERALL PERFORMANCE:   
● Efficiency 80% typical @ 12V DC Input Full Load
  85% typical @ 24V DC Input Full Load
  87% typical @ 48V DC Input Full Load
● Power Good Signal   TTL Compatible signal, on delay 100~500ms, off delay 1ms min
● Short Circuit Protection (SCP) All output equipped with SCP (shutdown and latch off)
● Over Power Protection (OPP) Peak power protected to 130%±10% of continuous rated power (shutdown and latch off)
● Over Voltage Protection (OVP) +5V or 12V or 24V DC
   
RELIABILITY:  
● MTBF (Mean Time Between Failure): 95 000 hours @max. Load, 6V DC & 25°C ambient
● Safety Standards Meet IEC 60950-1, EN 60950-1
● Safety Approved  
● EMI Compatibility (EMC) Standard EN 55032:2015/AC:2016, CISPR 32:2015, EN 6100-3-2:2014,
  EN 6100-3-3:2013, EN 55024:2010 +A1:2015
   
ISOLATION:
 
● INPUT and OUTPUT are isolated by transformers and optical couplers
● Dielectric Withstand: INPUT to OUTPUT: 500V DC for 60 seconds
● Dielectric Withstand: INPUT to FRAME GROUND: 500V DC for 60 seconds
● Leakage Current: <0.005μA @ 6V, 12V, 24V, 48V DC
   
Output Connector specific:  
● 25A/300V UL Approved 3-Pin Terminal
   
Power Chassis Dimension:  
● 140(L) x 147(W) x 40.5(H) mm / 5.51(L) x 5.78(L) x 1.59(H) Inches / STC-1230012IW
● 148(L) x 147(W) x 40.5(H) mm / 5.83(L) x 5.78(L) x 1.59(H) Inches / all other models
   
Net Weight:  
● 1.2 kg / 2.65 lbs
   
Gross Weight:  
● 2.1 ~ 2.4 kg / 4.63 ~ 5.29 Lbs
   
Packing Detail  
● 8 pcs
   
Measurement of Carton  
● 0.028 m3 / 1 Cuft

DOWNLOAD_chassis_drawing_STC-DTD-1UW-140-20200715
DOWNLOAD_specification_STC-XX600XXIW.pdf
DOWNLOAD_CHASSIS DRAWING_STC-DTD-1UW-148-20200930.pdf